Posted in November 5th, 2008
Reid and I went back to Copper Mountain in order to install a relay board in our GoldenEagle monitoring unit. This unit monitors the signal that is broadcast. The relay board will interface with our remote control and allow the site to tell us when we have an issue with the signal being broadcast. Another […]
read more from this topic.....
Posted in November 1st, 2008
There were no real issues at the site this time, but since I was in the area I decided to stop by and perform a software update on the HD Radio Equipment. On top of Antelope Butte again…
read more from this topic.....
Posted in October 31st, 2008
Once I had finished in Sundance I headed over to Newcastle to rewire that site as well… Relay panels re-wired…
read more from this topic.....
Posted in October 30th, 2008
Over the past year or so I have been rewiring the remote controls at our transmitter sites to clean up old wiring and give us more useful status and control from the sites. I had completed most of them but six sites remained. This week I set out to finish Sundance and Newcastle. At the […]
read more from this topic.....
Posted in October 25th, 2008
Over the past couple of days I had been receiving reports of extremely high temperatures at a site again…This time from Gillette…I decided to make the trip up to the site to check it out. Arrived on site in UW88…
read more from this topic.....
Posted in October 11th, 2008
This weekend I received reports of high temperatures at our Rock Springs site. I found this extremely strange since it was actually quite cold outside and snowing…The 100+ degree temperatures were actually causing equipment to shut down. Since UW88 was in the shop, I loaded my truck and headed for the site. Made it to […]
read more from this topic.....
Posted in October 9th, 2008
About a year ago we installed a dish at our Rawlins translator to replace an unreliable over-the-air feed from Laramie. The mounting pole for the old dish was not quite as stable as it should have been. In addition the dish was damaged over the winter and needed to be replaced. We decided to install a […]
read more from this topic.....
Posted in September 20th, 2008
Shouldn’t have said it was too quiet… I received a report around 12:30 on Friday afternoon that our station in Sundance was repeating the same snippet of audio over and over again. Great… I could not really do anything about this remotely so I just shut the transmitter off and hit the road for Sundance. […]
read more from this topic.....
Posted in September 12th, 2008
As I was driving back to Laramie from Jackson, I noticed that our Rock Springs station was silent. I went to the site and was greeted by a HUGE herd of elk on the site of the hill. One of them had antlers larger than I had ever seen on a wild animal. Once I […]
read more from this topic.....
Posted in September 3rd, 2008
I saw a sight recently that every engineer DREADS seeing… We had received a report that our signal in Riverton was off the air and had been for quite some time. Since this is just a translator we do not have any direct monitoring of it and rely on listener reports to tell us if […]
read more from this topic.....